HONEYWELL FC-SDO-0824數字輸出
1.產 品 介 紹
品牌：HONEYWELL
型號：HONEYWELL FC-SDO-0824
產品說明：數字輸出
優勢：供應進口原裝正品，專業停產配件。
2.產 品 詳 情 資 料：
HONEYWELL FC-SDO-0824電纜選擇和交叉參考三條電纜可用于連接模塊面板連接器和接線盒。這些電纜的唯一區別是它們的長度。這些電纜在模塊端部具有直角連接器，以盡量減少模塊前面所需的空間。這三條電纜取代了三條帶有直接頭的過時電纜。使用下表為16點模塊選擇正確的電纜I/O面板I/O面板（目錄號IC693ACC334）具有24針連接器，通過0.5、1或2米電纜連接到適用的接線板。該面板取代了所列模塊上的標準接線板。I/O面板安裝步驟1：在DIN導軌上安裝接線板組件將接線板放置在DIN導軌的所需位置上并卡入到位。HONEYWELL FC-SDO-08241.打開塑料接線板向上推頂桿以釋放接線板。朝著你的方向抓住拉片，直到觸點與模塊外殼分離，掛鉤脫離，以便完全取下。HONEYWELL FC-SDO-0824
Cable Selection and Cross-Reference Three cables are available for connecting between the module’s faceplate connector and the terminal block.HONEYWELL FC-SDO-0824The only difference in these cables is their length. These cables have right-angle connectors on the module end to minimize the space required in front of the modules. These three cables replace three obsolete cables that had straight connectors. Use the following table to select the correct cable I/O Face Plate for 16-Point Modules The I/O Face Plate (catalog number IC693ACC334) has a 24-pin connector, which provides the connection to the applicable terminal block through a 0.5,HONEYWELL FC-SDO-0824 1, or 2 meter cable. This face plate replaces the standard terminal board on the listed modules.I/O Face Plate Installation Step 1: Install terminal block assembly on DIN rail Place the terminal block over the desired location on the DIN rail and snap into place.1.Open the plastic terminal board Push up on the jacking lever to release the terminal block. Grasp pull-tab towards you until contacts separated from module housing and hook disengaged for full removal.HONEYWELL FC-SDO-0824
3.產 品 展 示
4.公 司 優 勢
5.關 于 我 們
本篇文章出自瑞昌明盛自動化設備有限公司官網，轉載請附上此鏈接:http://www.qing-ting.cn
