FANUC A02B-0303-C205位置檢測接口單元
DPM1隨后切換到清除狀態。如果此參數被禁用，則DPM1即使在發生故障時也保持在操作狀態，用戶可以控制系統的反應。另請參閱第49頁的設置選項卡。同步和凍結模式除了DPM1（DP Master Class 1）和分配的從設備之間的正常循環通信外，主設備還可以通過多播向一組從設備發送控制命令同步和凍結。使用sync命令，尋址的從設備將將輸出凍結在當前狀態。當輸出狀態保持不變時，主機接收的新輸出值將被存儲。在接收到下一個同步命令之前，不會將存儲的輸出數據發送到輸出。使用“unsync”命令終止同步模式。
The DPM1
subsequently switches to the clear state. If this parameter is disabled, the DPM1
retains in the operate state even in the event of a fault and the user can control the
reaction of the system. Please refer also to Settings Tab on page 49.
Sync and Freeze Mode
In addition to the normal cyclic communication between the DPM1 (DP Master
Class 1) and the assigned slaves, a master can send the control commands sync and
freeze via multicast to a group of slaves.
With the sync-command the addressed slaves will freeze the outputs in their current
state. New output values received by the master will be stored while the output
states remain unchanged. The stored output data are not sent to the outputs until the
next sync command is received. The Sync mode is terminated with the “unsync”
command.
