ENTERASYS A2H254-16 P0973BK網絡交換機
如果命令操作需要數據，則必須使用有效數據寫入命令數據寄存器。所選命令將在收到有效傳輸后立即執行。消息格式和示例：對PQM執行重置（操作代碼1）。功能代碼16-廣播命令在多個設備菊花鏈的應用程序中，可能需要通過發送一個命令來同步所有設備中的時鐘（日期和/或時間）。廣播命令允許如下示例所示的同步。如果從屬地址以0消息格式發送，則PQM將識別為廣播命令。示例：向PQM發送廣播命令，以存儲1:27:10.015 pm從屬地址1 00廣播命令（地址=0）功能代碼1 10存儲多個設置點數據起始地址2 00 F0從地址00F0設置點數量2 00 04 4個設置點=8字節字節字節字節總計BYTE計數1 08 8字節數據數據1 2 0D 1B小時（24小時格式），分鐘
The Command Data registers must be written with valid data if the command operation requires data. The selected command will be executed immediately upon receipt of a valid transmission. MESSAGE FORMAT AND EXAMPLE: Perform a reset on PQM (operation code 1).Function Code 16 - Broadcast Command In applications where multiple devices are daisy chained, it may be necessary to synchronize the clocks (date and/or time) in all the devices by sending one command. The broadcast command allows such synchronization as shown in an example below. The PQM will recognize a packet as being a broadcast command if the SLAVE ADDRESS is transmitted as 0.MESSAGE FORMAT AND EXAMPLE: Send broadcast command to the PQM to store 1:27:10.015 pm SLAVE ADDRESS 1 00 broadcast command (address = 0) FUNCTION CODE 1 10 store multiple setpoints DATA STARTING ADDRESS 2 00 F0 start at address 00F0 NUMBER OF SETPOINTS 2 00 04 4 setpoints = 8 bytes total BYTE COUNT 1 08 8 bytes of data DATA 1 2 0D 1B hours (24 hour format), minutes
