TRICONEX 9667-910自動化工控模塊
直徑功率
輸入直徑。直徑的通孔需要。直徑上的直徑為安裝螺栓必須為型帶帽螺釘，軸詳螺紋孔最小深度檢查孔，頂部和底部堵頭凹進飛邊和軸封提供全深度端銑鍵槽換向解析器或高分辨率輸出電機前端鐘形角半徑吊鉤詳高分辨率電機端軸和導向公差最大軸跳動軸端隙最大導向偏心度最大端面跳動銘牌法蘭安裝詳單位：毫米和英寸反饋目錄編號描述鍵端銑鍵槽全深度旋轉(zhuǎn)器，無制動器，,無制動器，,×，,高分辨率無制動器無制動器至。
如果訂購帶有可選制動器額定值的，則和增加增加。尺寸符合標準和。軸公差符合，公差。，系列，交流伺服電機出版物年月電機輸出軸徑向負載與。推力載荷徑向載荷推力徑向載荷磅推力磅徑向載荷推力軸向力徑向力交流伺服電機小時軸承壽命垂直或水平安裝，系列，交流伺服電機出版物年月伺服電機選項本節(jié)提供了有關可用各種選項的詳細信息，扭矩加伺服電機。整體保持制動器選件當斷電時，盤式制動器為彈簧設置。其設計用于保持負載靜止，并為緊急停止提供有限的制動扭矩。制動器不打算用作定位制動器制動器間隙最大為弧分，也不打算連續(xù)循環(huán)以幫助停止負載。
Diameter power
Enter the diameter. Diameter through hole is required. The diameter on the diameter is that the mounting bolt must be a type cap screw. See the minimum depth inspection hole of the threaded hole for the shaft, Top and bottom plug recessed flash and shaft seal provide full depth end milling keyway reversing resolver or high-resolution output motor front end bell angle radius hook See high-resolution motor end shaft and guide tolerance Maximum shaft runout Maximum shaft end clearance Maximum guide eccentricity Maximum end runout Nameplate flange installation Details Unit: mm and inch Feedback catalog number Description Key end milling keyway full depth rotator, without brake, without brake,, ×，, High resolution no brake no brake to.
If ordering with optional brake ratings, add and. The dimensions comply with the standards and. Shaft tolerance complies with, tolerance., Series, AC Servo Motor Publications Month Motor Output Shaft Radial Load vs. Thrust load Radial load Thrust radial load Thrust pound Radial load Thrust axial force Radial force AC servo motor Hourly bearing life Vertical or water safe installation, series, AC servo motor publication Monthly servo motor options This section provides detailed information about the various options available, torque plus servo motor. Integral holding brake option When power is off, the disc brake is spring set. It is designed to hold the load stationary and provide limited braking torque for emergency stop. The brake is not intended to be used as a positioning brake. The brake clearance is maximum minutes of arc, and it is not intended to circulate continuously to help stop the load.
