FET3251COP1B4COH2流量計,FET3251COP1B4COH2怎么使用
存儲大型配置使用CPU 36x的90-30系列PLC最多支持32個DSM314或DSM324模塊。當其他智能模塊用于PLC，如APM和GBC模塊。也可以減少什么時候：PLC中的機架數量增加；邏輯、運動和AUP文件的總大小增加；應用程序使用C邏輯塊或C邏輯程序；或連接的編程器或HMI設備用于讀取參考內存或故障表。
FET3251COP1B4COH2流量計在某些情況下，可能會增加DSM314或CPU將在硬件配置中接受的DSM324模塊先存儲邏輯，然后分別存儲配置。CPU350和CPU36x不適用支持硬件配置對于CPU31x/32x/33x/34x/374硬件中包含任何CPU35x或CPU36x型號的應用程序配置通?？梢源鎯Φ饺魏纹渌?.00或更高版本的CPU35x或CPU36x模型，然后執行。但是，嘗試存儲包含CPU31x、32x、33x、34x或374到CPU35x或CPU36x將出現故障。在連接多個編程器的情況下運行時，如果存儲操作是當加載操作已經在進行時，由一個程序員啟動加載請求將失敗。未清除轉換表當參考表變明朗。通過清除參考表時，不會清除轉換表程序員。
Storing Large Configurations
A Series 90-30 PLC using a CPU 36x supports a maximum of 32 DSM314 or
DSM324 modules. This number is reduced when other intelligent modules are
used in the PLC, such as APM and GBC modules. It may also be reduced
when:
The number of racks in the PLC increases;
The total size of logic, motion and AUP files increases;
The application uses C logic blocks or a C logic program; or
Connected programmers or HMI devices are used to read reference
memory or fault tables.
In some cases it may be possible to increase the number of DSM314 or
DSM324 modules that the CPU will accept in the hardware configuration by
storing logic first and then storing the configuration separately.
CPU350 and CPU36x do not
support hardware configurations
for CPU31x/32x/33x/34x/374
An application that contains any CPU35x or CPU36x model in the hardware
configuration can usually be stored to any other release 9.00 or later CPU35x
or CPU36x model and then executed. However, attempting to store a
hardware configuration that contains a CPU31x, 32x, 33x, 34x or 374 to a
CPU35x or CPU36x will fail.
Simultaneous Load and Store
When operating with multiple programmers attached, if a store operation is
initiated by one programmer, while a load operation is already in progress, the
load request will fail.
Transition Tables are not cleared
when the reference tables are
cleared.
The transition tables are not cleared upon clearing the reference tables through
the programmer.
