3HAC12928-1機器人特性模件,DSQC604中文PDF說明書在線閱讀
執行器定位警報和可能主狀態錯誤。
狀態LED/綠色。測量LVDT一次電壓。
1、如果測得的振蕩器電壓小于0.7 VRMS然后LVDT主要故障。
2.如果電壓大于0.7 VRMS，則LVDT pri mary良好，并且伺服內存在其他一些故障閥門、執行器或相關部件導致了錯誤。執行器定位警報和可能次級不良地位狀態LED/綠色。測量LVDT二次電壓。
3HAC12928-1機器人特性模件1.如果一個或另一個LVDT二元上沒有電壓，則該二次輸出發生故障。
2錯誤任何獨立產品或控制系統的可靠性都是受設備維護的影響。貝利控制
公司建議所有設備用戶實施預防性維護計劃，以保護設備以最佳水平運行。
本節介紹了可以執行的程序現場。這些預防性維護程序應
用作指導方針，幫助您建立良好的預防措施維護實踐。選擇所需的最小步驟滿足系統的清潔需求。
Actuator positioning
alarm and possible
bad primary status.
Status LED/green. Measure the LVDT primary voltage.
1. If the measured oscillator voltage is less than 0.7 VRMS
then the LVDT primary has failed.
2. If the voltage is greater than 0.7 VRMS then the LVDT primary is good and some other malfunction within the servo
valve, actuator or related component has caused the error.
Actuator positioning
alarm and possible
bad secondary
status.
Status LED/green. Measure the LVDT secondary voltages.
1. If no voltage is present on one or the other LVDT secondary, that secondary output has failed.
2. If both secondaries have voltage, then the LVDT secondaries are good and some other malfunction has caused the
error.The reliability of any stand-alone product or control system is
affected by the maintenance of the equipment. Bailey Controls
Company recommends that all equipment users practice a preventive maintenance program that will keep the equipment
operating at an optimum level.
This section presents procedures that can be performed
on-site. These preventive maintenance procedures should be
used as guidelines to assist you in establishing good preventive
maintenance practices. Select the minimum steps required to
meet the cleaning needs of your system.
