KCEU14201F51PEB模塊,KCEU14201F51PEB使用產品
HSS模塊上有31個跳線。這些跳線
選擇選項，如伺服閥或I/H轉換器模式，四I/H轉換器模式、伺服閥輸出電流和交流或直流LVDT中的應急錯誤定位為20毫安變壓器。表3-6列出了HSS模塊跳線設置。
圖3-2顯示了跳線的詳細信息。圖3-1顯示了J31在高速鋼電路板上的位置。將跳線設置為滿足特定系統的要求。要在模塊安裝單元中安裝HSS模塊：1.定位模塊安裝單元插槽分配單元
KCEU14201F51PEB模塊2.檢查模塊安裝單元背面的輸入/輸出擴展總線分流器插座。雙極分流器必須安裝時所有針腳均短路。從MFP模塊到輸入/輸出模塊必須有通信路徑。
3、將電路卡的上邊緣和下邊緣與模塊安裝單元中指定插槽的頂部和底部導軌。4、將模塊滑入插槽。推動直到模塊位于背板連接器中。轉動2個指旋螺釘在面板上旋轉?圈，直到模塊鎖定到位。here are 31 jumpers on the HSS module. These jumpers
select options such as servo valve or I/H converter mode, four
to 20 milliamp positioning for contingency errors in I/H converter mode, servo valve output current, and AC or DC LVDT
transformers. Table 3-6 lists the HSS module jumper settings.
Figure 3-2 shows details of the jumpers. Figure 3-1 shows the
location of J31 on the HSS circuit board. Set the jumpers to
meet the requirements of your particular system.To install the HSS module in the module mounting unit:
1. Locate the module mounting unit slot assignment for the
module.
2. Check the I/O expander bus dipshunt socket on the backplane of the module mounting unit. The dipshunt must be
installed with all pins shorted. There must be a communication path from the MFP module to the I/O module.
3. Align the top and bottom edges of the circuit card with the
top and bottom rails of the assigned slot in the module mounting unit.
4. Slide the module into the slot. Push until the module is
seated in the backplane connector. Turn the 2 thumbscrews
on the faceplate ?-turn until the module locks in place.
