5SHY4045L0001冗余模塊,5SHY4045L0001可控硅
電源模塊
每個Tricon底盤配備兩個電源模塊
完全能夠在以下位置運行5SHY4045L0001
滿載和額定溫度。每個源模塊可以在線更換。
電源模塊位于左側機箱側面，轉換線路電源
適用于所有Tricon的直流電源模塊。系統接線板
接地、輸入電源和硬接線報警位于下部背板的左角。新當選的
額定功率應為最小值每個電源240瓦。
電源模塊報警觸點為
啟動時間：
?模塊缺失
5SHY4045L0001冗余模塊
系統
?硬件配置
與控制程序的沖突
邏輯配置
?模塊故障
?主處理器檢測系統
過錯
?電源模塊的主電源
失敗
?電源模塊具有“低
“電池”或“溫度過高”
警告
警告：不要使用模型
8312 Tricon系統中的電源模塊
位于危險位置的
并且必須滿足ATEX要求。如果
您的線路電壓為230 V
系統必須滿足ATEX要求，
使用8311型24 VDC電源
Power Modules
Each Tricon chassis is equipped with
two Power Modules—either one is
fully capable of running the Tricon at
full load and rated temperature. Each
Power Module can be replaced online.
The Power Modules, located on the left
side of the chassis, convert line power
to DC power appropriate for all Tricon
modules. Terminal strips for system
grounding, incoming power and hard
wired alarms are located on the lower
left corner of the backplane. Incoming
power should be rated for a minimum
of 240 watts per power supply.
The Power Module alarm contacts are
actuated when:
? A module is missing from the
system
? The hardware configuration
conflicts with the control program’s
logical configuration
? A module fails
? A Main Processor detects a system
fault
? Primary power to a Power Module
fails
? A Power Module has a “Low
Battery” or “Over Temperature”
warning
WARNING: Do not use the Model
8312 Power Module in Tricon systems
that are located in hazardous locations
and must meet ATEX requirements. If
you have 230 V line voltage and your
system must meet ATEX requirements,
use the Model 8311 24 VDC Power
