NDCU-12CK數字量輸入輸出模塊,NDCU-12CK培訓教程
熱插拔過程中報告的故障
使用上述推薦設備時，熱插拔可能導致NDCU-12CK
與模塊及其輸入/輸出電路的丟失或添加相關的預期故障報告。這些
應以正常方式清除故障。但是，熱插拔rev。J或更高版本
模塊不會導致配置不匹配錯誤，在某些類型的系統中，這些錯誤可能會關閉關閉控制器。
熱插拔期間的輸入/輸出模塊數據
如上所述，熱插拔時必須關閉單獨的輸入/輸出模塊電源。當
模塊已安裝并重新通電，模塊數據將快速恢復正常。對于
智能輸入/輸出模塊，當模塊通過其
通電順序。
微場處理器的熱插拔
可以如上所述移除/插入J版或更高版本的微現場處理器。
然而，請注意，盡管微現場處理器將在重新安裝后開始工作，
必須重新加載MFP的應用程序。由微現場處理器控制的輸入/輸出數據
在完成之前將不正確。NDCU-12CK數字量輸入輸出模塊（Micro Field Processor的配置不是
受熱插拔影響）。
Faults Reported During Hot Insertion/Removal
When using the recommended equipment listed above, Hot Insertion/Removal may cause the
expected fault reports related to the loss of or addition of the module and its I/O circuits. These
faults should be cleared in the normal manner. However, Hot Insertion/Removal of a rev. J or later
module will NOT cause Configuration Mismatch errors that in some types of systems can shut
down the controller.
I/O Module Data During Hot Insertion/Removal
As mentioned, separate I/O module power must be turned off for Hot Insertion/Removal. When the
module is installed and power is reapplied, module data will quickly return to normal. For
intelligent I/O modules, there may be a delay of a few seconds while the module goes through its
powerup sequence.
Hot Insertion/Removal for a Micro Field Processor
A Micro Field Processor that is revision J or later may be removed/inserted as described above.
Note, however, that although the Micro Field Processor will start functioning upon reinstallation,
the MFP's application program must be reloaded. I/O data controlled by the Micro Field Processor
will be incorrect until that has been done. (The configuration of the Micro Field Processor is not
affected by Hot Insertion/Removal).
