INDRAMAT TVD1.3-08-03伺服驅動器
?圖4–38：設定值第5頁–測試/開關輸入模擬?模擬：輸入ON從實際開關輸入切換到編程模擬開關。模擬完成后，將此設定點設置為OFF。?SIMULATION ENABLED FOR（模擬啟用時間）：選擇將啟用模擬的所需時間長度。編程時間過去后，開關輸入模擬將關閉。如果選擇了UNLIMITED（未限制），則將使用模擬開關輸入，直到通過模擬開/關設定點或通過串行端口關閉模擬，或直到PQM中的控制電源斷開。?開關輸入A/B/C/D：輸入要模擬的開關輸入狀態（打開或關閉）。4.6.6僅供工廠使用?維修密碼：這些信息僅供GE Multilin人員訪問，僅用于測試和維修。
?FIGURE 4–38: Setpoints Page 5 – Testing / Switch Inputs Simulation ? SIMULATION: Enter ON to switch from actual switch inputs to the programmed simulated switches. Set this setpoint OFF after simulation is complete. ? SIMULATION ENABLED FOR: Select the desired length of time that simulation will be enabled. When the programmed time has elapsed, switch input simulation will turn off. If UNLIMITED is selected, the simulated switch inputs will be used until simulation is turned off via the simulation on/off setpoint or via the serial port or until control power is removed from the PQM. ? SWITCH INPUT A / B / C / D: Enter the switch input status (open or closed) to be simulated. 4.6.6 Factory Use Only ? SERVICE PASSCODE: These messages are for access by GE Multilin personnel only for testing and service.
