FOXBORO FBM211 P0916BT電源模塊
任何設定點或測量值都可以選擇為默認消息。消息按選擇順序顯示。3.4.2添加默認消息使用和鍵顯示要添加到默認消息隊列中的任何設置點或?qū)嶋H值消息，并遵循以下步驟。當選擇要顯示為默認值的設置點消息時，不要使用和鍵修改值，否則PQM會將該鍵識別為存儲設置點，而不是選擇默認消息。如果已經選擇了10條默認消息，則刪除第一條消息，并將新消息添加到隊列末尾。3.4.3刪除默認消息使用/鍵顯示要刪除的默認消息。如果不知道默認消息，請等待PQM開始顯示它們，然后將其記錄下來。如果未對默認消息進行編程，則PQM將保持在當前消息上，并且在默認消息時間延遲到期后，顯示變暗至S1 PQM SETUP\PPREFERENCES\default message BRIGHTNESS中指定的級別。
Any setpoint or measured value can be selected as a default message. Messages are displayed in the order they are selected. 3.4.2 Adding a Default Message Use the and keys to display any setpoint or actual value message to be added to the default message queue and follow the steps shown below. When selecting a setpoint message for display as a default, do not modify the value using the and keys or the PQM will recognize the key as storing a setpoint instead of selecting a default message If 10 default messages are already selected, the first message is erased and the new message is added to the end of the queue. 3.4.3 Deleting a Default Message Use the / keys to display the default message to be erased. If default messages are not known, wait until the PQM starts to display them and then write them down. If no default messages have been programmed, the PQM will remain on the current message and the display dims to the level assigned in S1 PQM SETUP \ PREFERENCES \ DEFAULT MESSAGE BRIGHTNESS after the DEFAULT MESSAGE TIME delay expires.
轉載請附上此鏈接：http://www.qing-ting.cn/
