SA811F主控板卡,ABB產品重量
? 不要短路。? 不要拆卸、變形或施加過大壓力。
? 不要加熱或焚燒。? 不要直接使用焊料。
? 不要使用不同型號的電池，也不要將新舊電池一起使用。? 不要充電。
? 始終檢查正確的極性?？删幊潭〞r(shí)器在本地處理器可用的資源中，有許多可編程定時器。定時器并入PIB控制器，并Z8536 CIO設備如圖1-1和圖3-1所示。他們可編程為對處理器產生周期性中斷。間隔計時器
SA811F主控板卡PCI-ISA網橋控制器有三個內置計數器，用作可編程間隔計時器。計數器分組為一個計時器PIB控制器中的定時器1裝置。每個計數器輸出都有一個特定的功能：? 計數器0與中斷請求行IRQ0相關聯。它可能是用于系統計時功能，例如時間功能。
? 計數器1為ISA內存生成刷新請求信號。這MVME2700中未使用計時器。
? 計數器2為上的揚聲器輸出功能提供音調PIB控制器（揚聲器輸出信號，可通過電纜連接至通過遠程重置連接器連接外部揚聲器）。間隔計時器使用OSC時鐘輸入作為其時鐘源。這個
MVME2700使用14.31818 MHz時鐘源驅動OSC引腳。
16位定時器MVME2700上有四個16位定時器。PIB控制器提供一個16位計時器；Z8536 CIO設備提供了另外三種。
有關對這些計時器進行編程的信息，請參閱Winbond W83C553 PIB控制器和Zilog Z8536 CIO設備。串行通信接口MVME2700使用Zilog Z85230 ESCC（增強串行通信控制器）來實現兩個串行通信接口，通過P2路由。Z85230支持同步（SDLC/HDLC）和異步協議。這個MVME2700硬件支持110B/s的異步串行波特率至38.4Kb/s。
? Do not short circuit.
? Do not disassemble, deform, or apply excessive pressure.
? Do not heat or incinerate.
? Do not apply solder directly.
? Do not use different models, or new and old batteries together.
? Do not charge.
? Always check proper polarity.
Programmable Timers
Among the resources available to the local processor are a number of
programmable timers. Timers are incorporated into the PIB controller and
the Z8536 CIO device as diagrammed in Figure 1-1 and Figure 3-1. They
can be programmed to generate periodic interrupts to the processor.
Interval Timers
The PCI-ISA Bridge controller has three built-in counters that serve as
programmable interval timers. The counters are grouped into one timer
unit, Timer 1, in the PIB controller. Each counter output has a specific
function:? Counter 0 is associated with interrupt request line IRQ0. It can be
used for system timing functions, such as a timer interrupt for a
time-of-day function.
? Counter 1 generates a refresh request signal for ISA memory. This
timer is not used in the MVME2700.
? Counter 2 provides the tone for the speaker output function on the
PIB controller (the SPEAKER_OUT signal which can be cabled to an
external speaker via the remote reset connector).
The interval timers use the OSC clock input as their clock source. The
MVME2700 drives the OSC pin with a 14.31818 MHz clock source.
16-Bit Timers
Four 16-bit timers are available on the MVME2700. The PIB controller
supplies one 16-bit timer; the Z8536 CIO device provides the other three.
For information on programming these timers, refer to the data sheets for
the Winbond W83C553 PIB controller and the Zilog Z8536 CIO device.
Serial Communications Interface
The MVME2700 uses a Zilog Z85230 ESCC (Enhanced Serial
Communications Controller) to implement the two serial communications
interfaces, which are routed through P2. The Z85230 supports
synchronous (SDLC/HDLC) and asynchronous protocols. The
MVME2700 hardware supports asynchronous serial baud rates of 110B/s
to 38.4Kb/s.
