GVC703AE01集成控制卡件,GVC703AE01可控硅模塊
ASPC2 PROFIBUS控制器統計
ASPC2 LAN控制器維護以下計數器。它們都是1字節長。什么時候這些計數器達到255，在清除之前保持在255。對于AOP，計數器名稱相同作為AOP標記名。ErrInvReqLen計數器寄存器Local：Slot:S.Data[19]的低位字節（位0-7）統計無效的請求長度錯誤。當掃描儀軟件向LAN控制器發送的消息太長的這是一個內部錯誤，不應發生。ErrFifo計數器
GVC703AE01集成控制卡件寄存器Local：Slot:S.Data[19]的高位字節8-15統計FIFO溢出錯誤。這些當LAN控制器無法足夠快地寫入內存時，會發生錯誤。這是一個內部錯誤，不應發生。ERRRXOVERRUN計數器寄存器Local：Slot:S.Data[20]的低位字節，位0-7，統計接收溢出錯誤。這是一個內部錯誤，不應發生。ErrDblTok計數器寄存器Local:Slot:S.Data[20]的高位字節8-15統計雙令牌錯誤。這些當多個節點認為自己擁有令牌或存在連接錯誤時，可能會發生錯誤，復制節點，等等。掃描儀撤回到“不持有令牌”狀態（決定沒有令牌），并等待直到再次將令牌傳遞給它。ErrRespErr計數器
寄存器Local：Slot:S.Data[21]的低位字節為0-7，用于統計消息發送時的響應錯誤失敗或目標沒有響應。此錯誤可能是由于硬件損壞或故障裝電線。
ErrSyniErr計數器寄存器Local:Slot:S.Data[21]的高位字節8-15表示一般網絡錯誤。這些錯誤發生在網絡出現問題時，但在您建立網絡之前超時錯誤。
ASPC2 PROFIBUS Controller Statistics
The ASPC2 LAN controller maintains the following counters. They are all 1 byte long. When
these counters reach 255, they hold at 255 until cleared. For AOP, the counter name is the same
as the AOP tag name.
The ErrInvReqLen Counter
The low byte of register Local:Slot:S.Data[19], bits 0-7, counts invalid request length errors.
These errors occur when the scanner software gives the LAN controller a message that is too
long. This is an internal error and should never occur.
The ErrFifo Counter
The high byte of register Local:Slot:S.Data[19], bits 8-15, counts FIFO overflow errors. These
errors occur when the LAN controller cannot write to memory fast enough. This is an internal
error and should never occur.
The ErrRxOverun Counter
The low byte of register Local:Slot:S.Data[20], bits 0-7, counts receive overrun errors. This is an
internal error and should never occur.
The ErrDblTok Counter
The high byte of register Local:Slot:S.Data[20], bits 8-15, counts double token errors. These
errors may occur when more than one node thinks it has the token or there are wiring errors,
duplicate nodes, and so on. The scanner withdraws to the “not hold token” state (decides it
doesn't have the token) and waits until it gets the token passed to it again.
The ErrRespErr Counter
The low byte of register Local:Slot:S.Data[21], bits 0-7, counts response errors when a message
fails or there is no response from the destination. This error may be due to bad hardware or faulty
wiring.
The ErrSyniErr Counter
The high byte of register Local:Slot:S.Data[21], bits 8-15, indicates general network errors.
These errors occur when there are problems on the network, but before you get a network
timeout error.
